-
-
Sabarkantha, Gujarat-383215
Designer Door
Our Brochures
Designer Door (IS:2202)
SILICON designer doors are specified where absolute face aesthetic uniformity is desired. These doors are laminated with high-pressure laminate sheet of 1mm and 0.8mm. The base door is manufactured by seasoned battens and frames with waterproof PF resin. Laminate doors are available in broad range of design options, using high quality laminate sheet for zero maintenance and long life.
| TECHNICAL SPECIFICATIONS IS:2202 | |||
|---|---|---|---|
| # | Test | ISI Requirement | Observed Value |
| 1 | Dimension | Length, Width +/- 5 mm Thickness +/- 1 mm. | Within limits |
| 2 | Squareness | Deviation not more than 1mm on a length of 500 mm | Deviation below 1mm |
| 3 | General Flatness | Twist, cupping, warping not to exceed 6 mm | - |
| 4 | Local Planeness | Depth of deviation at any point to be less than 0.5mm | Within limits |
| 5 | Impact Indentation Test | Depth of indentation not to exceed 0.2 mm | Within limits |
| 6 | Edge Loading Test | Deflection of edge with max, To be less than 5 mm | Within limits |
| 7 | Shock Resistance Test | No Visible defect after test | No Visible Defects |
| 8 | Buckling Test | Initial deflection - < 50mm residual deflection - < 5mm | Within limits |
| 9 | Slamming Test | No visible damage after Test | No visible damage |
| 10 | Misuse Test | No deformation after Test | No deformation |
| 11 | Varying Humidity Test | No visible warping, twisting, or de-lamination | No such defects observed |
| 12 | End Immersion Test | No de-lamination at the end | No de-lamination |
| 13 | Knife Test | Minimum pass standard | Excellent |
| 14 | Glue Adhesion Test | No de-lamination | No de-lamination |
| 15 | Screw Withdraw Test | Load to withdraw screw to be more than 1000N | Load -> 1000 N |
